Jump to content

What is this called?


Sean Barker

Recommended Posts

Had a bit of a mechanical today and on closer inspection found that this part had cracked and partly come away from the crank.

I obviously need to order a new one but am not sure what its actually called or where to order it from, any help?

It's for a Shimano hollowtech

bebmdw.jpg

Here it is

 

mr8i6f.jpg

Goes in here

Link to comment
Share on other sites

  • 4 weeks later...

Sean, I've only just seen this thread, The end cap is used to pre-load the bearing, the round plastic tool allows a very very small torque to be applied using your fingers before clamping the two crank arm pinch bolts.

Should you need the installation checking, don't hesitate to call in as I have all the workshop tools for fitting and removal of b/bkt, crank arm and a torque wrench for torques as low as 7.5 Nm.

Alan.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...